News

Location: Home>News
What precautions should be taken to prevent the quality of webbing
Author: Editor Time : 2023-09-19 20:47:41

1、 Dimensions

1. The uneven thickness of the raw materials results in varying sizes of the fabric. 2. The steel buckle is worn too large or too little, causing the fabric to have a certain size.

3. The weft wheel is loose during operation. 4. The weft yarn passes through the rod spring, and there are yarn hairs running inside.

Preventive measures for ribbon processing:

1. Regularly measure the width of the webbing and adjust it immediately if any defects are found. 2. Thread the steel buckle not too large or too small. If it is not qualified, wear it again. Do not force the production. 3. Tighten and fix the weft roller. 4. Regularly loosen the spring on the outside to allow the yarn and wool inside to come out.

2、 Yin Yang Color

Reason for formation:

1. The raw materials have color differences. 2. Uneven pressing of the pan head 3. Uneven threading of the steel buckle

Preventive measures:

1. There is no need to replace the fuzz or the pan head. 2. Press the pan head heavily. 3. Place the weft needle in the middle of the opening.

3、 Skip stitch

Reason for formation:

  1. The needle blocking rod is not properly blocked. 2. The position of the weft needle and the knitting needle is not properly align

Precautions for Ribbon Factory:

1. Position the needle lever against the weaving needle 2. Align the weft needle and the weaving needle in place so that the weft yarn can be fully hung

Ribbon Factory

4、 Disposition of easily dirty areas

Reason for formation:

1. Brown silk pieces are too dirty. 2. All conveyor shafts are too dirty. 3. All areas with yarn passing through are not clean enough

Preventive measures:

1. Take tissue paper and chalk from the accessory room and wipe the brown silk clean. 2. Wipe all the passing shafts clean. 3. Wipe all the areas where yarn passes through and can be touched clean

5、 Waves rise on both sides

Reason for formation: 1. The steel buckle is unevenly threaded, with small yarns on both sides and more yarns in the middle. 2. The steel buckle is too small to be threaded

Preventive measures:

1. Choose the appropriate steel buckle and wear it according to the regular method. 2. The steel buckle should be worn more appropriately and not too large or too little

6、 Line

Reason for formation:

1. The bottom yarn is thicker than the veil. 2. The steel buckle threading method is incorrect, and the bottom yarn is not covered. 3. The selection of steel buckles is too sparse, and there are too many yarns worn in each empty space.

Precautions for Ribbon Supply:

1. Change the thicker base yarn to the outermost edge, or replace it without adding another one. 2. Choose appropriate steel buckles and use one or two sets of threading methods. 3. Generally, try to use 1 or 2 sets of dressing methods instead of 3 or more.